Peugeot 308 Key Fob Replacement
Peugeot's 308 is slightly old however it's still eye-catching. It's not the plushest car in its class - it's a Ford Focus or Volkswagen Golf will shield you from imperfections on the road - but it's still a pleasant and comfortable driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant the following tips will aid.
Water Damage
If you accidentally drop your key fob in an eddy, or it is wet while kayaking, canoeing, rafting, or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry container whenever you are outside or perform things that expose it to excessive water.
It's also crucial to ensure sure that the fob has dried out before you open the fob and then use it. If you detect any smells emanating from the fob like an industrial-like liquid smell or windshield washer fluid, this is another sign that it's submerged in water.
A circuit board that's damp can cause the battery to dump its charge, or even explode. If you can pull your 308 keyfob out of the water it is best to turn the button side up and shake as much water out as possible before opening the casing. Once you have opened it, remove the battery and clean the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system might not function include a dead coin battery or receiver module issues, signal interference, or an electronic chip that is defective. If none of these is the problem, you can try resetting your system by disconnecting the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start that lets drivers start their car from an extended distance, which allows them to warm up or cool down the vehicle before they enter. This feature is extremely helpful particularly during the winter's cold and chilly months. However, there are times when the remote start system stops working due to a variety of reasons, like the battery in the coin is dead.
The coin-shaped battery located inside the key fob could last between two and four years, based on how often it's used, where it was purchased, and how it is used. The date of use is printed on the packaging or marked in the user's manual.
If the key fob has stopped working after exposure to clean tap water and you want to remove the battery, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to become damaged. It is recommended to replace it.
If you are not sure the battery is in good condition, you can test its voltage with a multimeter that is set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts it is time to replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, it's possible the receiver module has developed a fault. It's the component that sends a signal to the car when your key fob is activated, which acts as an immobiliser and prevents it from starting until the correct key is used.
This could be caused by many factors, including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in, the electronic chip on the inside will be damaged. In this case you will have to remove it and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the issue continues to persist, it is recommended that you visit a local Peugeot expert or locksmith. They will be able to utilize a diagnostic tool to identify the problem and fix it.
It is stressful to lose your Peugeot car key. However, a professional auto locksmith can address the issue in just a few minutes. They can program your vehicle and cut a brand new, functioning key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is a very crucial component of the remote control system. If it is damaged, your car might not start or you might receive a message saying "anti-theft active". If this occurs, the only option to fix the issue is to get a new key. Professional auto locksmiths can provide this service in the shortest time.
The chip inside the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If peugeot key fob www.g28carkeys.co.uk was exposed to dirty or soapy water, it should be cleaned right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. Then, you need to let the battery dry completely.
Sometimes, a key fob can be inoperable due to radio interference. This could be due to other devices operate on the same frequencies as your Peugeot keyfob. This could be due to poor conditions or objects within the vicinity of the vehicle. If you experience this issue it is advised to visit the Peugeot dealership.
The Peugeot Key Fob 207/308 is very delicate and requires special attention. You should not drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset the onboard computer by disconnection of the battery for a few minutes. Disconnect the negative cable prior to the positive.